Steiner 1230-X Flame Resistant Jacket X-large

Product Description

The STEINER 1230-X is a flame resistant jacket built for industrial and trade environments where heat, sparks, and molten spatter are daily hazards. Constructed from a cotton and leather blend, it provides both flexibility and durability in demanding work conditions. The jacket weighs in at 9.5 oz material weight and is sized for a 52-54 inch chest, fitting X-Large workers who need full-coverage upper-body protection. Bar-tacked stress points and leather reinforcement extend service life in high-wear areas. Non-reflective snaps keep the closure low-profile in environments where reflective hardware could be a concern. Welders, ironworkers, and pipefitters are the primary users of this garment type.

This jacket is suited for use in welding shops, fabrication facilities, and field pipe work where NFPA 70E or similar arc flash and flame hazard standards apply. The gray and green colorway is common in industrial settings. With a single front pocket and snap front closure, the design stays simple and snag-resistant. It is appropriate for both shop and outdoor jobsite use where a full-sleeve protective outer layer is required over standard work clothing.

Key Features

• Flame resistant and retardant construction for protection against sparks and heat exposure
• Cotton and leather blend combines breathability with abrasion resistance
• Bar-tacked stress points for extended durability at high-wear areas
• Leather-reinforced panels add extra protection in critical zones
• Non-reflective snaps reduce glare and snag risk in confined or low-clearance work areas
• 52-54 inch chest sizing provides a true X-Large fit for unrestricted movement

Compatibility

Designed as an OEM-style flame resistant outer garment for industrial trades requiring heat and spark protection in welding, fabrication, and similar high-temperature work environments.

Installation Notes

This garment is donned and inspected by the wearer before each use. Check all snap closures and inspect leather and cotton panels for wear, burn-through, or damage before entering a hazardous work area. Follow your facility safety program and applicable NFPA or OSHA standards for personal protective equipment selection and use. Launder or clean only per manufacturer garment care instructions to maintain flame resistant properties.