Stanley FMHT73558 Aviation Snip Set 3 Piece

Product Description

The STANLEY FMHT73558 is a 3-piece aviation snip set designed for cutting sheet metal, plastic laminate, and similar materials in HVAC, mechanical, and general sheet metal fabrication work. The set includes left-cut, right-cut, and straight-cut snips, covering the full range of cutting directions needed on the job. Each snip measures 10 inches overall length with a 1-15/16 inch length of cut. Color-coded handles follow the standard industry convention: red for left-cut, green for right-cut, and yellow for straight-cut, allowing fast identification in a tool bag or on a bench. These snips are suited for journeymen and apprentice sheet metal workers, HVAC installers, and plumbers working with thin-gauge metal.

Aviation snips in this configuration are standard issue for residential and light commercial HVAC ductwork fabrication and installation. The three-cut set handles straight runs, inside curves, and outside curves. Typical applications include cutting galvanized sheet metal duct, flashing, and trim stock. The 10-inch overall length provides leverage for extended cutting without hand fatigue. The set is packaged as a single kit, making it a practical addition to a new technician tool kit or a replacement for worn individual snips.

Key Features

• 3-piece set includes left-cut (red), right-cut (green), and straight-cut (yellow) snips
• Color-coded handles follow industry standard for fast cut-direction identification
• 10-inch overall length for controlled leverage and reach
• 1-15/16 inch length of cut per snip
• Covers full range of cutting directions for sheet metal ductwork and flashing

Compatibility

Designed for general sheet metal cutting tasks common in HVAC ductwork fabrication, flashing installation, and light-gauge metal trimming applications.

Installation Notes

Sheet metal snips are a hand tool requiring no power source or special installation. Always wear cut-resistant gloves when working with sheet metal edges. Inspect snip blades before use for chips or misalignment that could cause binding or ragged cuts. Keep blades lightly oiled at the pivot point to maintain smooth operation and extend service life.