Spi 95-710-0 Pin Punch 1/8 Inch 8 Inch Oal

Product Description

The SPI 95-710-0 is a pin punch designed for driving out roll pins, dowel pins, and drift pins in mechanical assemblies. The punch measures 1/8 inch in tip diameter with an overall length of 8 inches, placing it in the 7 to 9.9 inch length range. It is a hand-driven tool used with a hammer or mallet to remove and seat pins in housings, brackets, and shaft assemblies. Machinists, millwrights, HVAC technicians, and general maintenance professionals reach for this punch when working on equipment that requires controlled pin removal without damaging surrounding components.

This pin punch is suited for bench work and field service applications where precise pin driving is required. It works on residential and commercial mechanical equipment, including motor mounts, linkage assemblies, and structural hardware. The 8-inch overall length provides enough reach to work in confined areas while keeping the user's hand clear of the strike zone. It is sold individually as a single-piece unit.

Key Features

• 1/8 inch tip diameter for driving standard fractional pin sizes
• 8 inch overall length for reach in confined workspaces
• Pin punch type — purpose-built for pin removal and seating, not for cold-work or chiseling
• Single-piece unit — sold individually with no minimum quantity beyond one

Compatibility

Designed as a general-purpose pin punch for use with standard 1/8 inch roll pins, dowel pins, and drift pins found in common mechanical and equipment assemblies.

Installation Notes

Pin punches are used by machinists, millwrights, and maintenance technicians working on mechanical assemblies. Always de-energize and lock out equipment before driving or removing pins from powered components. Use a ball-peen or cross-peen hammer appropriate to the application — avoid using the punch as a pry tool or cold chisel, as this can damage the tip or shank. Eye protection is required any time a punch is used with a hammer.