Speed Queen 685715WP Washer Front Dispenser Drawer

Product Description

The SPEED QUEEN 685715WP is a front dispenser drawer designed to hold and release detergent, bleach, and fabric softener into the wash system during programmed cycle stages. The drawer slides into the front control housing where internal water jets flush stored cleaning agents into the washer tub at the correct points in the cycle. It connects to the dispenser housing through control rails and inlet channels, maintaining controlled chemical flow throughout normal washer operation. This part is typically installed or replaced by appliance service technicians during routine maintenance or when dispenser components fail to release agents properly.

This dispenser drawer is intended for use in residential front-load and top-load washers where chemical dispensing is managed through a front-access drawer assembly located in the upper front panel of the machine. It is compatible with Speed Queen and Amana branded washers that use this drawer-style dispenser configuration. This part directly replaces the earlier part number 685715W.

Key Features

• Holds detergent, bleach, and fabric softener in separate compartments for staged release
• Slides into front control housing for tool-free removal and reinstallation
• Internal water jets flush agents into the washer tub at programmed cycle points
• Connects via control rails and inlet channels to the dispenser housing
• Direct replacement for original part number 685715W

Compatibility

Compatible with Speed Queen and Amana washers that use a front-access drawer-style dispenser assembly. This part replaces the superseded part number 685715W.

Installation Notes

This part is typically serviced by a qualified appliance technician. Before removing or replacing the dispenser drawer, disconnect power to the washing machine at the outlet or circuit breaker. Slide the drawer fully out of the housing to remove it, noting the orientation of any retaining tabs or locking clips. Avoid forcing the drawer into the housing, as misalignment can damage the inlet channels or control rails.