Snappy 200-205 Galvanized Wallstack 2.25x10x60 in

Product Description

The SNAPPY 200-205 is a galvanized steel wallstack duct fitting measuring 2.25 inches by 10 inches by 60 inches. Wallstacks are flat, rectangular duct sections designed to run inside wall cavities, delivering conditioned air from a floor or baseboard register to the main trunk line or plenum above. This fitting ships in a 5-foot length and is used in residential forced-air HVAC systems where space between wall studs is limited. HVAC installers select this profile when a standard round or oval duct will not fit the framing layout. The galvanized steel construction resists corrosion in typical indoor air-distribution environments.

Wallstacks of this size are standard in residential new construction and retrofit HVAC work. The 2.25-inch by 10-inch cross-section fits within a standard stud-bay wall cavity and connects to matching wallstack collars, end caps, or boot fittings. This fitting is appropriate for supply-side low-velocity air distribution in residential gas, oil, or heat-pump forced-air systems installed by licensed HVAC technicians or qualified sheet metal contractors.

Key Features

• Galvanized steel construction for corrosion resistance in indoor duct applications
• 2.25 x 10 x 60 inch profile fits standard residential wall-cavity installations
• 5-foot length reduces the number of joints needed in taller wall runs
• Rectangular cross-section maximizes airflow within tight framing bays
• Compatible with standard wallstack fittings, boots, and collars of the same cross-section

Compatibility

Designed as an OEM-style replacement or new-installation fitting for residential forced-air HVAC duct systems requiring a 2.25-inch by 10-inch wallstack profile.

Installation Notes

Wallstack installation is performed by licensed HVAC technicians or sheet metal contractors. Shut down and lock out the air-handling unit before cutting into or joining existing ductwork. Seal all joints with UL 181-listed duct mastic or metal-foil tape per local mechanical code requirements. Sheet metal snips, a hand seamer, and drive cleats are the standard tools for field fitting and connection.