Seco Tools F70029 Controller 120V 16A 140C

Product Description

The SECO TOOLS F70029 is a replacement controller designed to regulate equipment operations with precise control over electrical switching and load management. Rated for 120/250 volts at 50/60 Hz, it handles a full load current of 16 amps (FLA) and a locked rotor current of 96 amps (LRA), making it suitable for motor-driven equipment commonly found in HVAC and refrigeration systems. With a maximum operating temperature of 140 degrees C and a power draw of 3.5 VA, the F70029 is built to handle demanding service environments. It meets cURus certification standards, confirming compliance with safety requirements for both US and Canadian installations. Licensed HVAC technicians and refrigeration mechanics are the primary installers for this component.

The F70029 is suited for residential and light commercial applications where a direct OEM-style controller replacement is required. It is appropriate for systems that demand reliable switching under full motor load conditions, including compressor and fan motor circuits operating on single-phase power at 120 or 250 volts. Installation is typically performed during scheduled maintenance or in response to controller failure causing erratic equipment operation or no-start conditions.

Key Features

• Dual voltage rating: 120/250 volts at 50/60 Hz for broad application flexibility
• Full Load Current (FLA) of 16 amps with Locked Rotor Current (LRA) of 96 amps
• Rated to 140 degrees C maximum operating temperature
• Low standby power consumption at 3.5 VA
• cURus certified for US and Canadian safety compliance
• OEM-style replacement part for consistent fit and performance

Compatibility

Designed as an OEM-style replacement controller for equipment requiring a 120/250-volt, 16-amp rated switching controller operating at 50/60 Hz.

Installation Notes

Installation should be performed by a licensed HVAC technician or qualified electrician. Disconnect and lock out all power to the unit before removing the existing controller or handling any wiring. Verify that the replacement controller ratings match the equipment nameplate data before energizing the system. Work should comply with applicable NEC requirements and local electrical codes.