Seco 02575415 Turning Insert CP200 Solid Carbide Mdt

Product Description

The SECO 02575415 is a solid carbide multi-directional turning insert engineered for precision grooving and turning applications. Built to LCMF insert style standards, this double-ended neutral-hand insert carries a CP200 manufacturer grade with a micrograin carbide substrate and a PVD-applied TiAlN/TiN coating. It delivers a maximum cutting width of 0.197 inches and a cutting height of 0.177 inches, with a 0.016-inch corner radius. The chipbreaker geometry is FT, and the relief angle is 7 degrees. Machinists and CNC turning specialists install this insert on multi-directional turning toolholders in production and job-shop environments.

The 02575415 is designed for the MDT (Multi-Directional Turning) series and is rated for primary workpiece materials classified as Superalloy and Titanium (ISO material groups M and S). These material groups include difficult-to-machine alloys commonly found in aerospace, medical, and energy components. The insert is suited for both roughing and finishing passes where controlled chip formation and edge stability are critical. At 0.630 inches in length, it fits standard LCMF-style toolholders used in CNC lathes and turning centers across light-duty to medium-duty production runs.

Key Features

• CP200 grade micrograin solid carbide substrate for toughness in difficult-to-machine alloys
• PVD-applied TiAlN/TiN coating for heat resistance and extended edge life
• FT chipbreaker geometry designed for controlled chip evacuation
• Double-ended neutral-hand design doubles usable cutting edges per insert
• 7-degree relief angle reduces rubbing and supports clean surface finish
• Maximum cutting width of 0.197 inches and insert length of 0.630 inches

Compatibility

Designed for use in LCMF-style multi-directional turning toolholders. Style designation LCMF160504-0500-FT confirms fitment within the MDT series toolholder system. Verify toolholder seat and clamping compatibility before installation.

Installation Notes

This insert is installed by machinists or CNC tooling technicians. Power down and lock out the machine before seating or replacing inserts. Use the appropriate torx or hex key specified by the toolholder manufacturer when clamping the insert — do not overtighten. Inspect the insert seat and clamping mechanism for wear or debris before installation to ensure proper seating and edge alignment.