Schlage Electronics 9002RS 2-relay Control Board

Product Description

The SCHLAGE ELECTRONICS 9002RS is a 2-relay control board designed for electrified (EL) panic device applications in commercial and institutional access control systems. It provides the switching logic required to integrate panic hardware with electronic access control, allowing door releases to be managed through low-voltage relay outputs. The board is compact at 7 inches long, 4.3 inches wide, and 2.9 inches tall, and weighs 0.1 pounds, making it straightforward to mount within a door frame assembly or nearby enclosure. Licensed security or access control technicians are the typical installers for this type of hardware.

This control board is intended for use in commercial and institutional buildings where electrified panic exit devices must interface with an access control system. Typical applications include corridors, stairwells, and main egress points requiring both life-safety panic egress and electronic access management. It is sold as an individual unit and fits into new installations or retrofit scenarios where a relay control board must be replaced or added to an existing EL panic device assembly.

Key Features

• Dual-relay output configuration supports independent switching of two circuits in a single EL panic device setup
• Compact form factor at 7 inches x 4.3 inches x 2.9 inches simplifies mounting within tight door hardware assemblies
• Lightweight construction at 0.1 pounds reduces mechanical load on door frame mounting points
• Designed for electrified panic device integration in commercial and institutional egress applications
• Single-unit sale allows for direct replacement or addition to existing hardware without purchasing in bulk

Compatibility

Designed as an OEM-style replacement or addition for electrified panic exit devices requiring a 2-relay control board interface in commercial access control installations.

Installation Notes

Installation should be performed by a licensed access control or low-voltage security technician familiar with electrified panic hardware and applicable local codes. Disconnect and lock out all power to the door control system before removing or installing the control board. Verify relay wiring terminations match the existing system diagram before restoring power. Installations in commercial egress paths may be subject to NFPA 101 life-safety code requirements and local AHJ inspection.