Sandvik Coromant 5753584 Grooving Insert TLG3 H13A

Product Description

The SANDVIK COROMANT 5753584 is a solid carbide, uncoated grooving insert in the Top Lok series, designed for precision grooving and parting operations on CNC lathes and turning centers. It features a left-hand cutting orientation with a 1.57 mm (0.0620 inch) cutting width and a maximum depth of cut of 2.39 mm (0.0940 inch). The H13A grade uncoated carbide substrate is well suited for materials that benefit from a sharp, bright edge with minimal built-up edge risk. This insert is installed by machinists and toolroom technicians performing external or internal grooving, undercutting, and profile turning applications.

This insert is intended for use in Top Lok series grooving toolholders compatible with size 3 insert seats. It is applicable to a range of turning operations including groove-to-shoulder, plunge grooving, and face grooving on production and job-shop lathes. The neutral rake geometry with a 10-degree rake angle supports controlled chip formation across a variety of workpiece materials. The ISO code for this insert is TLG-3062L H13A, which can be referenced when cross-matching to compatible toolholder systems.

Key Features

• Solid carbide construction with bright/uncoated H13A grade finish for sharp cutting performance
• Left-hand cutting orientation for dedicated left-hand grooving setups
• 1.57 mm (0.062 inch) cutting width with a 0.19 mm (0.0075 inch) corner radius
• Maximum depth of cut range of 2.00 mm to 3.00 mm (0.0750 to 0.1000 inch)
• 10-degree rake angle with neutral rake geometry for broad material compatibility
• Top Lok series size 3 insert seat for secure, repeatable seating in compatible toolholders

Compatibility

Designed for use in SANDVIK COROMANT Top Lok series grooving toolholders accepting a size 3 insert seat. The ISO designation TLG-3062L H13A can be used to verify fitment with compatible toolholder systems.

Installation Notes

Installation should be performed by a qualified machinist with the machine powered down and locked out per applicable lockout/tagout procedures. Seat the insert fully into the Top Lok toolholder pocket and tighten the clamping screw to the toolholder manufacturer specification before resuming operation. Inspect the insert seat and clamping surfaces for chips or debris before seating a new insert, as contamination can cause improper seating and premature edge failure. Do not exceed the maximum depth of cut rating for this insert grade.