Sandvik Coromant 5733393 Cutoff Insert 2mm Carbide Corocut Xs

Product Description

The SANDVIK COROMANT 5733393 is a solid carbide cutoff insert in the CoroCut XS series, designed for parting and grooving operations on CNC lathes and turning centers. It carries a 2.00 mm (0.0787 inch) cutting width, a 15-degree left-hand lead angle, and a 6-degree relief angle. The insert features a TiAlN/TiN PVD coating over a grade 1025 carbide substrate, delivering wear resistance in both steel and stainless steel applications. A clamp-style holding method locks the insert securely in compatible CoroCut XS toolholders. Licensed machinists and CNC operators install this insert in production and job-shop turning environments.

This insert is suited for small-diameter parting, shallow grooving, and face grooving on bar-fed or chucked workpieces where tight groove widths and clean surface finish are required. The MACL chipbreaker geometry and 0.05 mm corner radius support controlled chip formation in close-tolerance cuts. It is particularly applicable in medical, aerospace, and general precision machining where a 2.00 mm slot width and a maximum depth of cut of 8.50 mm (0.3346 inch) meet the job requirement.

Key Features

• Solid carbide construction with PVD-applied TiAlN/TiN coating for extended tool life
• 2.00 mm cutting width with 0.05 mm corner radius for precise, narrow grooves
• 15-degree left-hand lead angle with MACL chipbreaker geometry for controlled chip evacuation
• Maximum depth of cut of 8.50 mm (0.3346 inch) handles most small-diameter parting tasks
• Clamp-style insert holding ensures repeatable seating and quick indexing
• Grade 1025 carbide substrate compatible with a broad range of workpiece materials

Compatibility

Designed for use in CoroCut XS series toolholders that accept an insert seat size 3 with a clamp-style holding method. Verify toolholder designation and insert seat size before ordering.

Installation Notes

Installation should be performed by a qualified machinist or CNC setup technician with the machine in a fully stopped, locked-out state before insert exchange. Use the manufacturer-specified clamp screw and torque driver to seat the insert — do not overtighten by hand tools alone. Inspect the insert pocket and clamping surfaces for chips or contamination before seating the new insert. Confirm lead angle direction (left hand) matches the toolholder orientation before beginning the cut.