Rivetking 12N75RFLSP Solid Rivet Flat Head Steel

Product Description

The RIVETKING 12N75RFLSP is a flat-head solid rivet manufactured from uncoated steel. Solid rivets provide a permanent, high-strength mechanical fastening solution used across a wide range of structural and sheet-metal assembly applications. This rivet features a body diameter of 0.125 inches and a length under head of 0.75 inches. Installation requires a bucking bar and rivet gun or hammer to cold-form the tail, creating a secure, vibration-resistant joint. It carries no special military specification rating. Fabricators, ironworkers, HVAC sheet-metal mechanics, and general maintenance technicians routinely work with solid rivets of this type.

This solid rivet is suited for light structural, ductwork, and general metal fabrication tasks where a permanent fastener is required. The flat head profile sits flush or near-flush against the workpiece surface, making it appropriate for assemblies where a low-profile head is necessary. The uncoated steel construction is appropriate for interior or protected applications where corrosion exposure is limited.

Key Features

• Flat head profile for low-profile installation on metal assemblies
• 0.125 inch body diameter for use in standard light-gauge applications
• 0.75 inch length under head suits typical sheet and light structural material stacks
• Uncoated steel construction provides solid mechanical performance in dry, protected environments
• Permanent fastening method resists vibration loosening over service life

Compatibility

Designed as an OEM-style solid rivet for general metal fabrication, sheet-metal ductwork, and structural assembly applications requiring a 0.125 inch diameter flat-head fastener.

Installation Notes

Solid rivets are installed by licensed sheet-metal mechanics, ironworkers, or maintenance technicians using a rivet gun and bucking bar, or hammer-set tooling. Always de-energize and lock out any equipment being serviced before drilling rivet holes or driving fasteners. Ensure hole diameter is matched to the rivet body diameter per applicable fabrication standards. Do not reuse solid rivets once set; drill out and replace if joint disassembly is required.