Rittal 8601050 Ts Plinth Side Trim Panel Ral 7022 2-pack

Product Description

The RITTAL 8601050 is a TS plinth side trim panel designed for use with base and plinth enclosure components. Manufactured from spray-finished sheet steel in RAL 7022 umbra grey, these trim panels provide a finished appearance between front and rear plinth components on TS enclosure systems. Each package contains two 100 mm tall panels. At a 200 mm plinth height, two 100 mm trim panels can be stacked to achieve full coverage. Panels may also be rotated 90 degrees to help stabilize bayed plinth configurations. This hardware is typically installed by electricians and enclosure integrators during panel shop builds or field enclosure installations.

These plinth side trim panels are suited for industrial and commercial enclosure applications where TS series base and plinth components are used. They mount between the front and rear plinth sections to close off the side opening, maintaining a clean enclosure perimeter at floor level. They are appropriate for new enclosure builds as well as modifications to existing TS system installations where additional trim or stabilization of bayed plinths is required.

Key Features

• 100 mm panel height allows stacking two panels to cover a 200 mm plinth
• Can be rotated 90 degrees to stabilize bayed base and plinth components
• Spray-finished sheet steel construction for durability in enclosure environments
• RAL 7022 umbra grey finish for consistent appearance with TS enclosure system components
• Includes assembly hardware; sold as a pack of 2 panels

Compatibility

Designed for use with RITTAL TS series base and plinth components, mounting between front and rear plinth sections. Specific compatible enclosure model numbers were not provided in the available product data; verify fitment against your TS enclosure plinth configuration before ordering.

Installation Notes

Installation is typically performed by electricians or enclosure assembly technicians. De-energize and lock out the enclosure system before performing any internal modifications or mounting work. Panels should be fitted between the plinth front and rear components using the included assembly hardware; rotation to 90 degrees is an option when stabilizing bayed plinth runs. Follow applicable NFPA 70 (NEC) requirements for enclosure grounding and bonding after assembly.