Rittal 8601000 Enclosure Plinth Component 1000 Mm

Product Description

The RITTAL 8601000 is a front and rear base plinth component designed for use with Rittal modular enclosure systems. Each set consists of one trim panel and two pre-assembled corner pieces, finished in spray-applied RAL 7022 umbra gray with RAL 9005/7035 cover caps. The component measures 100 mm in height and 100 mm in depth (approximately 3.9 inches each), providing a clean finished base between the enclosure and the floor. It is fabricated from sheet steel and is intended for installation by licensed electricians and industrial control panel builders working with Rittal enclosure systems.

This plinth component is used at the base of Rittal modular enclosures in both residential and commercial industrial or electrical panel installations. It closes the gap between the enclosure bottom and the mounting surface, improving both aesthetics and protection. The 1000 mm width version is suited for wider enclosure bays in multi-panel lineups or standalone wide enclosures. Installation typically occurs during initial enclosure setup or when retrofitting an existing enclosure with a finished base.

Key Features

• Front and rear coverage in a single component set for consistent finished appearance on both faces
• 100 mm height (approximately 3.9 inches) provides standard plinth clearance for cable entry and leveling
• Spray-finished RAL 7022 umbra gray exterior with RAL 9005/7035 cover caps for a professional appearance
• Includes 2 base plinth components, 4 cover caps, and assembly hardware
• Pre-assembled corner pieces reduce field assembly time
• Compatible with multiple Rittal enclosure series for broad application flexibility

Compatibility

Designed for use with TS Type, TS IT Type, SE Type, CM Type, TP Type, PC Type, and IW Type Rittal enclosures.

Installation Notes

Installation is typically performed by licensed electricians or industrial panel builders during enclosure assembly or modification. De-energize and lock out the enclosure and all associated circuits before beginning any enclosure modification work. Standard hand tools are sufficient for assembly; follow the enclosure manufacturer instructions for proper alignment and fastening of plinth components. Ensure the mounting surface is level before securing the plinth to avoid enclosure racking.