Riten C4302 Face Driver Center Point Type 43

Product Description

The RITEN C4302 is a center point style face driver center designed for use with Face Driver Type 43 systems. This precision component transmits torque through the face of the workpiece while supporting it between centers, allowing full-length turning without a chuck. It accepts center hole diameters from 0.256 inches minimum to 0.386 inches maximum. The C4302 is a lightweight component at 0.02 pounds, suited for use on CNC lathes and manual turning centers in production and job shop environments. Installation and setup is typically performed by machinists and toolroom technicians working with between-centers turning operations.

The C4302 is used in between-centers turning applications where the workpiece must remain fully accessible along its entire length. It is compatible with Face Driver Type 43 configurations and is appropriate for residential and commercial machine shop environments requiring consistent center point engagement. The center point style suits workpieces with standard conical center holes in the 0.256 to 0.386 inch diameter range.

Key Features

• Center point style for standard conical center hole engagement
• Minimum center hole diameter of 0.256 inches for precise fitment range
• Maximum center hole diameter of 0.386 inches
• Designed for compatibility with Face Driver Type 43
• Lightweight at 0.02 pounds for minimal spindle load contribution

Compatibility

Designed for use with Face Driver Type 43 systems, accepting workpiece center holes with diameters between 0.256 inches and 0.386 inches.

Installation Notes

Installation is performed by qualified machinists following standard between-centers lathe setup procedures. Power down and lock out the machine before installing or removing face driver centers. Verify the center hole geometry of the workpiece matches the accepted diameter range before engaging the driver. Consult the face driver manufacturer documentation for proper seating and clamping force guidelines.