Rheem ig1034 Hot Surface Igniter Replacement

Product Description

The RHEEM ig1034 is a flat silicon carbide hot surface igniter designed for residential and commercial gas-fired heating equipment. It provides reliable spark-free ignition for furnaces, water heaters, and boilers. The unit ships with a mounting bracket, gasket, and an 8.5-inch lead harness with connector, allowing for a straightforward drop-in installation without sourcing additional hardware. CSA approval confirms the igniter meets recognized safety standards for gas appliance ignition systems. This part is intended for installation by licensed HVAC technicians or qualified gas appliance service professionals.

The ig1034 is suited for a broad range of gas-fired heating applications across both residential and light commercial settings. Compatible equipment includes forced-air furnaces, atmospheric and power-vent water heaters, and hydronic boilers. The flat silicon carbide element design is a widely adopted industry standard configuration, making this igniter a practical replacement option across multiple equipment types. Refer to your equipment service manual to confirm igniter element geometry and lead configuration before installation.

Key Features

• Flat silicon carbide element construction for consistent ignition performance
• Mounting bracket and gasket included — no additional hardware required
• 8.5-inch leads with pre-installed connector for direct harness connection
• CSA approved for gas appliance ignition service
• Manufactured in the USA
• Cross-referenced to Rheem OEM part 62-22669-92

Compatibility

Cross-referenced as a replacement for Rheem OEM part number 62-22669-92. Suitable for furnace, water heater, and boiler applications across residential and commercial gas-fired heating equipment. Verify element geometry, voltage rating, and lead length against the original part before installation.

Installation Notes

Hot surface igniters are installed by licensed HVAC technicians or gas appliance service professionals. Disconnect power to the appliance and shut off the gas supply before removing the existing igniter. Silicon carbide elements are fragile — handle by the lead wires or bracket only and avoid contact with the element surface. Confirm voltage compatibility between the igniter and the appliance control board before energizing the system.

Technical Specifications

• Igniter Type: Flat Silicon Carbide Hot Surface Igniter
• Lead Length: 8.5 inches
• Connector: Included
• Mounting Bracket: Included
• Gasket: Included
• Certification: CSA Approved
• Country of Origin: USA

Standard Information

• Brand: RHEEM
• Manufacturer Part Number: ig1034