Reed TC2QP Quick Release Tubing Cutter Plastic Pipe 8in

Product Description

The REED TC2QP is a quick release tubing cutter designed for cutting plastic pipe in plumbing, gas distribution, and utility installations. It accepts an outer diameter range of 1/4 inch to 2-5/8 inches, making it practical across small, medium, and large diameter work. The cutter measures 8 inches in length and weighs 1.2 pounds, keeping it manageable in tight spaces. The OP2 cutting wheel is rated for polyethylene (PE) and polybutylene (PB) pipe materials. Licensed plumbers and pipe fitting crews reach for this tool when clean, square cuts are needed on plastic distribution lines without the debris and deformation risk of sawing.

The TC2QP is suited for residential and light commercial plumbing applications where plastic pipe is the material of choice. It performs well in new construction rough-in, service replacement, and utility distribution work. The quick release mechanism allows the jaw to open wide for fast pipe loading and repositioning, which reduces fatigue during repetitive cutting tasks on the job. It is equally useful in confined crawlspaces or utility trenches where a conventional cutter with a slow-feed knob would slow the work down.

Key Features

• Quick release jaw mechanism for fast pipe loading across 1/4 inch to 2-5/8 inch OD range
• OP2 cutting wheel rated for PE and PB plastic pipe materials
• Compact 8-inch overall length suited for confined installation spaces
• Lightweight at 1.2 pounds for reduced hand fatigue during repetitive cuts
• Equivalent to Rigid part 152-P for direct tool replacement reference

Compatibility

Compatible with polyethylene (PE) and polybutylene (PB) plastic pipe in the 1/4 inch to 2-5/8 inch outer diameter range. Equivalent to Rigid part 152-P.

Installation Notes

This tool is typically used by licensed plumbers and pipefitters working with plastic distribution piping. Before cutting into an existing line, shut off flow and depressurize the section being serviced. Rotate the cutter around the pipe with steady, even pressure - avoid forcing the wheel, which can deform the pipe end and compromise a watertight fitting connection. Deburr the cut end before joining to fittings per applicable IPC or local plumbing code requirements.