Rational 60.74.548P Elbow DN40 875 Va

Product Description

The RATIONAL 60.74.548P is a DN40 elbow fitting rated at 875 VA, designed for use in commercial cooking equipment water and drain line assemblies. DN40 refers to a nominal pipe diameter of 40 millimeters, a standard sizing common in European-spec commercial kitchen equipment. This fitting directs flow at an angle within plumbing circuits inside or adjacent to RATIONAL combi oven and steam cooking units. Installation is typically performed by a commercial kitchen equipment technician or licensed plumber during scheduled maintenance or unit repair.

This elbow fitting is used in commercial foodservice environments where RATIONAL cooking equipment requires plumbing service. Typical applications include water supply and condensate drain line repairs on combi ovens and steam injection units. The 875 VA electrical rating indicates this component may be part of an electrically actuated valve or solenoid assembly within the unit plumbing circuit rather than a purely passive pipe fitting. Technicians servicing RATIONAL equipment in restaurants, institutional kitchens, and central production facilities will encounter this part.

Key Features

• DN40 nominal bore sizing compatible with standard metric commercial plumbing connections
• 875 VA rating supports use in electrically actuated plumbing assemblies
• OEM RATIONAL part number ensures direct fitment in supported equipment
• Designed for commercial foodservice plumbing and drain circuit applications

Compatibility

Designed as an OEM replacement elbow fitting for RATIONAL commercial cooking equipment plumbing assemblies where DN40 connections and 875 VA ratings apply.

Installation Notes

Installation should be performed by a qualified commercial kitchen equipment technician or licensed plumber familiar with RATIONAL equipment service procedures. Shut off water supply and disconnect electrical power to the unit before beginning any plumbing work. Verify local plumbing codes and manufacturer service documentation before replacing internal fittings. Do not overtighten fittings on threaded or push-fit DN40 connections.