Raindrip Inc 307025B 1/4 Inch Barbed Tee Fitting 25 Pack

Product Description

The RAINDRIP INC 307025B is a barbed tee fitting designed for use in low-volume drip irrigation systems. It connects 1/4-inch tubing to create branch lines or taps off a 1/2-inch hose, making it a core component for splitting and routing water flow in landscape and garden irrigation layouts. This fitting is compatible with tubing that has an inner diameter of 0.160 to 0.197 inches and is rated for water pressures up to 50 psi. It ships in a bulk pack of 25 units, making it practical for contractors and irrigation technicians running multiple zones or completing large-scale installations.

This fitting is used in residential and light commercial drip irrigation systems where 1/4-inch micro-tubing is routed to individual emitters, bubblers, or drip heads. It is suited for garden beds, landscaped areas, and container irrigation setups. The tee configuration allows the installer to branch a single 1/4-inch tube into a tee junction, or to tap two 1/4-inch branches off a 1/2-inch supply hose. It is installed by irrigation technicians and knowledgeable DIYers working with standard drip system components.

Key Features

• Barbed tee design secures tubing without tools or clamps
• Compatible with 1/4-inch tubing with 0.160 to 0.197 inch inner diameter
• Creates a 1/4-inch branch from a 1/4-inch tube or two 1/4-inch branches from a 1/2-inch hose
• Rated for water pressures up to 50 psi
• Bulk pack of 25 fittings for high-volume installation work

Compatibility

Designed for use with 1/4-inch drip irrigation tubing with an inner diameter of 0.160 to 0.197 inches. Also compatible for tapping two 1/4-inch branches from a 1/2-inch supply hose. For use with tube only, not threaded or compression fittings.

Installation Notes

Installation is typically performed by irrigation technicians or experienced DIYers. Shut off the water supply and relieve system pressure before inserting or removing fittings. Push the tubing firmly onto each barbed port until it seats fully against the fitting shoulder. Verify that operating pressure does not exceed 50 psi to prevent joint separation.