Radio Design Labs D-RN02 Wall-mounted Mic Line Dante Input

Product Description

The RADIO DESIGN LABS D-RN02 is a wall-mounted microphone and line-level audio input interface designed to bring analog audio signals onto a Dante digital audio network. It accepts mic or line-level sources and converts them for transmission over standard Ethernet infrastructure using the Dante protocol. The unit installs directly at the wall, keeping signal paths short and reducing cable runs back to a central rack. Audio engineers, AV integrators, and commercial sound contractors install this device in fixed-installation environments where distributed Dante networking is the backbone of the audio system.

The D-RN02 is suited for conference rooms, lecture halls, houses of worship, and similar commercial or institutional spaces where wall-mount input points are required at multiple locations across a Dante network. The wall-mount form factor allows placement near the source — podium walls, stage edges, or meeting room endpoints — feeding audio directly into the network without an outboard preamp or stagebox. No specific compatible model numbers or replacement part numbers were identified in the available product data.

Key Features

• Accepts both microphone-level and line-level analog audio inputs
• Converts analog audio to Dante network-compatible digital signal over standard Ethernet
• Wall-mount form factor allows source-point installation without additional rack hardware
• Designed for fixed-installation commercial and institutional AV applications
• Part of the RADIO DESIGN LABS Dante interface product family

Compatibility

Designed as an OEM-style input interface for use within Dante-based digital audio networks in fixed commercial AV installations.

Installation Notes

Installation should be performed by a qualified AV integrator or licensed low-voltage systems contractor familiar with Dante network configuration and audio signal routing. Power down or disconnect network switch ports before making Ethernet connections to the device. Wall rough-in and back-box preparation should comply with applicable local building and low-voltage wiring codes. Configure Dante channel routing through Dante Controller software after physical installation is complete.