Quam Solution 1 Ceiling Speaker Kit 20W Rms 8 Inch

Product Description

The QUAM SOLUTION 1 is a complete two-speaker installer package designed for indoor ceiling audio installations. The kit bundles every core component needed for a finished overhead speaker run: dual cone loudspeakers, 70-volt line transformers, steel stud mount baffles, load bearing supports, and steel back boxes. Each package delivers 20 watts RMS total output across both speakers, with a sensitivity rating of 95 dB and a frequency response of 60 Hz to 17 kHz. The 8-inch drivers carry an 8-ohm impedance. Licensed electricians and low-voltage audio installers are the primary trades for this product.

The SOLUTION 1 targets commercial and institutional indoor environments where distributed ceiling audio is required, such as offices, retail spaces, schools, and similar occupied buildings. The 70-volt transformer topology is standard for these multi-speaker distributed systems, allowing long cable runs with minimal signal loss. Each of the two installer sets in the package includes a C10X/BU/WS dual cone loudspeaker with a 10-ounce magnet, a TBLU 5W 25/70V transformer mounted to a BR8WS round steel stud mount baffle, one SSB-3 rust-resistant steel load bearing support, and one ERD8U 275 CID round steel back box.

Key Features

• Complete installer kit - two full speaker assemblies per package, including baffles, transformers, back boxes, and load bearing supports
• 8-inch dual cone loudspeaker with 10-ounce magnet per channel for extended dispersion
• 5W 25/70V transformer per speaker supports standard distributed 70-volt audio systems
• 95 dB sensitivity with 60 Hz to 17 kHz frequency response
• Round steel stud mount baffle and rust-resistant steel load bearing supports rated for structural ceiling installations
• RoHS compliant; manufactured in the United States

Compatibility

Designed for indoor ceiling installations using 25-volt or 70-volt distributed audio systems. Component part numbers included in this kit are C10X/BU/WS (loudspeaker), TBLU transformer, BR8WS baffle, SSB-3 load bearing support, and ERD8U back box.

Installation Notes

Installation should be performed by a licensed low-voltage technician or electrician familiar with distributed audio systems and applicable local codes. De-energize the amplifier and disconnect all source wiring before cutting ceiling openings or making speaker connections. The included load bearing supports are required for suspended or drop-ceiling installations to meet structural support requirements - do not omit them. Verify transformer tap selection matches the amplifier output voltage before completing wiring.