Qsc Llc D2I Single Gang Dante AES67 Wall Plate

Product Description

The QSC LLC D2I is a single-gang wall plate interface designed for Dante and AES67 networked audio environments. It provides a discreet, low-profile input point for connecting analog audio sources to a Dante-enabled network infrastructure. Installed flush in a standard single-gang wall box, the D2I converts local analog signals into network audio streams, allowing AV systems integrators and audio technicians to route audio over standard Ethernet without dedicated analog snake runs. It is suited for commercial AV installations where clean signal acquisition at the room edge is required.

The D2I is intended for commercial and professional AV deployments including conference rooms, lecture halls, houses of worship, and broadcast facilities. It fits into networked audio systems built on Dante or AES67 protocols, serving as a remote input node that feeds audio to a central DSP or amplifier platform. Installation is typically performed by licensed AV systems integrators or low-voltage technicians.

Key Features

• Single-gang form factor mounts in a standard wall box for a clean, finished appearance
• Supports Dante and AES67 networked audio protocols
• Converts local analog input to network audio stream over standard Ethernet
• Eliminates long analog cable runs in distributed audio systems
• Designed for commercial AV and professional audio infrastructure

Compatibility

Designed for use in Dante and AES67 networked audio systems. Compatible with Dante-enabled DSPs, amplifiers, and network audio devices. Specific model compatibility should be verified against the QSC LLC D2I product data sheet.

Installation Notes

Installation should be performed by a qualified low-voltage technician or licensed AV systems integrator familiar with networked audio systems. Power down or disconnect the network switch port before terminating Ethernet connections. Follow applicable local low-voltage wiring codes and consult the manufacturer data sheet for network configuration and device discovery procedures. Do not install in a single-gang box without confirming adequate depth for the rear terminations.