Pro-source TSL-750-LHD-IT-PRO Cable Ties 29.50in 50-pack

Product Description

The PRO-SOURCE TSL-750-LHD-IT-PRO is a standard cable tie designed for bundling and organizing wiring, conduit runs, and hose assemblies in electrical, HVAC, and plumbing installations. Molded from polyamide with a plastic pawl locking mechanism, each tie measures 29.50 inches in overall length and 0.30 inches in width, with a maximum bundle diameter of 8.74 inches. The natural color finish suits general-purpose indoor applications. These ties are sold in a pack of 50, making them a practical bench or service-van stock item for electricians, HVAC technicians, and plumbers who routinely dress and secure wiring harnesses or tubing during installation and service calls.

These cable ties are suited for indoor residential and commercial applications where large-diameter bundle management is required. The 8.74-inch maximum bundle diameter accommodates substantial wiring bundles, conduit groups, or refrigerant line sets during rough-in and finish work. The polyamide construction provides adequate tensile strength for typical trade bundling tasks. Each tie uses a one-piece plastic pawl design that locks in a single direction and does not require a separate tool to cinch. The pack quantity of 50 supports ongoing service work without repeated restocking.

Key Features

• 29.50-inch overall length handles long runs and large bundles
• Maximum bundle diameter of 8.74 inches accommodates substantial wiring groups or conduit clusters
• Plastic pawl locking style provides a secure, one-piece cinch without additional tooling
• Polyamide construction offers good tensile strength for general indoor bundling applications
• Natural color for standard indoor use; not rated for outdoor UV exposure
• Pack of 50 supports high-volume installation and service work

Compatibility

Designed as a general-purpose standard cable tie for indoor electrical, HVAC, and plumbing bundling applications where a 29.50-inch tie length and up to 8.74-inch bundle diameter are required.

Installation Notes

Cable ties of this type are installed by electricians, HVAC technicians, and plumbers as part of wiring dress and mechanical bundling tasks. Secure all wiring or tubing bundles only after confirming that power has been de-energized and lockout/tagout procedures are in place where required by NFPA 70 or applicable local codes. Trim the excess tail flush with the locking head using flush-cut diagonal pliers to avoid sharp edges that could damage insulation or cause injury. These ties are rated for indoor use only and should not be installed in direct-sunlight or exterior environments.