Pro-source TSL-370-S-YB-PRO Standard Cable Tie 16in Black

Product Description

The PRO-SOURCE TSL-370-S-YB-PRO is a standard-duty nylon cable tie designed for bundling, securing, and organizing wire harnesses, conduit runs, and hose assemblies. At 16 inches in length with a 50-pound tensile strength, it handles moderate-load bundling tasks across a wide range of trade applications. The black nylon construction resists UV exposure better than natural-colored ties, making it suitable for both indoor and outdoor installations. Rated for continuous use from -40 degrees F to 185 degrees F, this tie maintains its holding strength across the temperature swings common in mechanical rooms, rooftop equipment, and service panels. Each package contains 100 ties.

This cable tie is used by HVAC technicians, electricians, plumbers, and general mechanical contractors for wire management, conduit support, and equipment service work. The 16-inch length accommodates bundle diameters up to 4.17 inches, making it practical for larger wire bundles, grouped conduit, or multi-hose assemblies. The black color and nylon material make it a common choice for rooftop unit wiring, panel interior dressing, and any install where long-term UV resistance matters. Sold in a pack of 100, it suits both service van stock and job-site bulk use.

Key Features

• 50-pound tensile strength for reliable grip on moderate-load bundles
• 16-inch length accommodates bundle diameters up to 4.17 inches
• Black nylon construction provides better UV resistance than natural ties
• Operating temperature range of -40 degrees F to 185 degrees F
• Meets MIL-S 23190E, MIL-SPEC M20693B, and UL Listed standards
• Pack of 100 ties for stocking or job-site use

Compatibility

Standard one-piece self-locking cable tie design compatible with manual hand installation or standard cable tie installation tools used across HVAC, electrical, and plumbing trades.

Installation Notes

Cable ties are installed by hand or with a cable tie tensioning and cutting tool for consistent pull force and flush tail trim. When bundling wire harnesses near energized conductors, de-energize the circuit per NEC requirements before working inside panels or junction boxes. Avoid overtightening around insulated conductors, as excess tension can deform wire insulation. Cut excess tail flush after seating to prevent sharp edges that can cut hands during service.