Pro-source TSL-370-I-YT-PRO Standard Cable Tie 100 Pack

Product Description

The PRO-SOURCE TSL-370-I-YT-PRO is a standard-duty nylon cable tie designed for bundling and securing wire harnesses, conduit runs, and general-purpose lashing applications. At 14.6 inches long with a 0.14-inch strap width, it accommodates bundle diameters up to 4.17 inches and delivers a 40-pound tensile strength. The natural (translucent) color makes it suitable for both indoor and light-duty outdoor use where UV exposure is not a primary concern. Electricians, HVAC technicians, and plumbers reach for these ties when routing low-voltage wiring, securing refrigerant line insulation, or organizing conduit bundles during rough-in and finish work.

These cable ties are appropriate for residential and light commercial installations. Typical applications include wire management in electrical panels, securing flex duct or insulation wrap in HVAC systems, bundling supply and drain lines in plumbing rough-ins, and general service-van organization. The operating temperature range of -40 degrees F to 185 degrees F makes them suitable for most interior mechanical room and attic installations. This listing is sold as a 100-piece pack.

Key Features

• 14.6-inch length handles bundle diameters up to 4.17 inches
• 40-pound tensile strength for reliable, secure lashing
• Nylon construction rated from -40 degrees F to 185 degrees F
• Natural color compatible with standard one-way locking head
• Meets MIL-S 23190E, MIL-SPEC M20693B, and UL Listed standards
• 100 ties per pack with a minimum order quantity of 1 pack

Compatibility

Designed as a standard one-way locking cable tie for general electrical, HVAC, plumbing, and mechanical bundling applications where a 14.6-inch nylon tie with a 0.14-inch strap width is specified.

Installation Notes

Cable ties are installed by hand or with a cable-tie tensioning tool to achieve consistent pull force and a flush cut. When routing near sharp edges or heat sources, verify the 185 degrees F maximum temperature rating is not exceeded. Installers working in NEC-governed environments should confirm tie material and ratings meet local inspection requirements for the wiring method in use. Cut tails flush with the locking head to prevent sharp edges on finished installations.