Pro-source TSL-300-S-YY-PRO Standard Cable Tie 11.9in Yellow

Product Description

The PRO-SOURCE TSL-300-S-YY-PRO is a standard-duty nylon cable tie designed for bundling wires, hoses, and conduit runs in electrical, HVAC, and plumbing installations. At 11.9 inches in overall length with a 3/16-inch (0.19 inch) width, it delivers a rated tensile strength of 50 lb, making it suitable for light to medium bundling tasks. The yellow color aids in quick visual identification on the job. Compliant with MIL-S 23190E, MIL-SPEC M20693B, and UL 94 V-2, this tie meets recognized industry and military specifications. Electricians, HVAC technicians, and mechanical contractors commonly use ties of this type for wire management and equipment securing tasks.

This cable tie is appropriate for both residential and commercial applications where a reliable, single-use cinching fastener is needed. Typical uses include bundling low-voltage control wiring, securing HVAC drain lines, organizing conduit bundles, and routing harnesses inside air handlers or electrical panels. The yellow color makes it especially useful in installations where color-coded organization by circuit or system type is standard practice. The operating temperature range of -40 degrees F to 185 degrees F allows use in unconditioned spaces, attics, crawlspaces, and mechanical rooms.

Key Features

• 11.9-inch overall length accommodates bundles up to 84 mm in maximum diameter
• 50 lb tensile strength rating for dependable cinching on light to medium bundles
• Yellow color for quick visual identification and color-coded wire management
• Nylon construction rated for -40 degrees F to 185 degrees F operating range
• Meets MIL-S 23190E, MIL-SPEC M20693B, UL 94 V-2, and UL Listed standards
• 3/16-inch (0.19 inch) width fits standard cable tie mounting heads and tools

Compatibility

Designed as a standard one-piece nylon cable tie for general wire and hose bundling across electrical, HVAC, plumbing, and mechanical trade applications where a 11.9-inch, 50 lb-rated tie is specified.

Installation Notes

Cable ties of this type are installed by hand or with a tensioning tool; a flush-cut tool or diagonal cutters should be used to trim the tail after cinching to avoid sharp edges that can damage wire insulation or injure personnel. De-energize or lock out circuits before bundling live control wiring in accordance with applicable NEC lockout/tagout requirements. Single-use design means ties must be cut and replaced rather than reopened. Avoid over-tensioning, which can deform or cut into insulation on bundled conductors.