Pro-source TSL-250-I-YR-Pro Standard Cable Tie Red Nylon

Product Description

The PRO-SOURCE TSL-250-I-YR-Pro is a standard nylon cable tie designed for bundling, securing, and organizing wire harnesses, tubing, and cable runs in electrical, HVAC, and plumbing installations. Each tie measures 9.8 inches in overall length with a 0.14-inch width and delivers a 40-pound tensile strength. The red color supports color-coded identification in multi-circuit or multi-system installations. Rated for a temperature range of -40 degrees F to 185 degrees F, this tie performs in both indoor and outdoor service environments. Sold in packs of 100, it is suited for job-site stocking by electricians, HVAC technicians, and plumbers.

This cable tie is appropriate for residential and light commercial applications where standard-duty bundling is required. Common uses include securing low-voltage control wiring in HVAC systems, organizing conduit fill, bundling refrigerant line insulation, and managing plumbing supply lines. The red color makes it easy to distinguish specific wire groups or circuits during installation and service. The 2.76-inch maximum bundle diameter accommodates a range of wire harness sizes typical in trade work.

Key Features

• 40-pound tensile strength for reliable standard-duty bundling
• 9.8-inch length with 0.14-inch width fits a wide range of bundle sizes
• Maximum bundle diameter of 2.76 inches suits most residential wiring harnesses
• Red color enables color-coded circuit and system identification
• Rated -40 degrees F to 185 degrees F for indoor and outdoor use
• Meets MIL-S 23190E, MIL-SPEC M20693B, and UL Listed standards
• Pack of 100 for job-site and shop stocking

Compatibility

Designed as a standard-duty cable tie for general wire bundling and securing tasks across electrical, HVAC, plumbing, and pool service applications.

Installation Notes

Cable ties of this type are installed by electricians, HVAC technicians, and plumbers during rough-in and finish work. Power down circuits before securing wiring to avoid inadvertent contact. Use a cable tie tensioning tool for consistent cinch force and flush-cut the tail after seating to avoid sharp edges. Follow applicable NEC or local mechanical code requirements for wire support spacing and bundle sizing.