Pro-source TSL-150-I-YO-Pro Standard Cable Tie 40 Lb 6 in

Product Description

The PRO-SOURCE TSL-150-I-YO-Pro is a standard-duty nylon cable tie rated at 40 lb tensile strength and measuring 6 inches in overall length. Designed for wire bundling, cable management, and general fastening tasks, these orange ties are made from nylon and carry MIL-SPEC and UL Listed certifications. The orange color supports color-coded organization systems common in electrical, HVAC, and mechanical installations. Each pack contains 100 ties. The 0.13-inch width and maximum bundle diameter of 1.49 inches make these ties suitable for light to medium wire bundles in panels, conduit runs, and equipment enclosures.

These cable ties are used across residential and commercial applications wherever temporary or permanent wire management is needed. Typical install scenarios include electrical panel wiring, low-voltage control wiring in HVAC equipment, plumbing fixture rough-in bundles, and pool equipment wiring runs. The operating temperature range of -40 degrees F to 185 degrees F supports both indoor and outdoor use in most climate conditions. Electricians, HVAC technicians, plumbers, and general contractors regularly stock standard cable ties of this type as a consumable on service vehicles and job sites.

Key Features

• 40 lb tensile strength for reliable bundle retention
• 6-inch length with a maximum bundle diameter of 1.49 inches
• Orange color for visual identification in color-coded wiring systems
• Nylon construction rated from -40 degrees F to 185 degrees F
• MIL-S 23190E, MIL-SPEC M20693B, and UL Listed certifications
• Sold in a pack of 100 for job-site and service vehicle stocking

Compatibility

Designed as a standard-duty cable tie suitable for general wire bundling and cable management applications across electrical, HVAC, plumbing, and mechanical trades.

Installation Notes

Cable ties of this type are installed by hand or with a cable tie tension tool and cut-off tool to trim the tail flush after cinching. No power shutoff is required for the tie itself, but always de-energize circuits before working inside electrical panels or control enclosures per NEC requirements. Do not overtighten ties on insulated conductors to avoid deforming insulation. Dispose of trimmed tails promptly to prevent foreign object debris in equipment enclosures.