Pro-source TSL-100-M-YS-PRO Standard Cable Tie 4in Gray

Product Description

The PRO-SOURCE TSL-100-M-YS-PRO is a standard-duty nylon cable tie designed for bundling and securing wire, hose, and cable runs in electrical, HVAC, and general trade applications. At 4 inches in overall length with an 18 lb tensile strength, it handles light to moderate bundling tasks where a reliable, cost-effective fastener is needed. The gray nylon construction resists moisture and performs across a wide temperature range, from -40 degrees F to 185 degrees F. Sold in minimum order quantities of 100, this tie is a shop-stock staple for service vans and panel shops alike.

This cable tie is suited for residential and light commercial installations where wire management, harness dressing, or conduit bundle organization is required. HVAC technicians use ties like this to secure low-voltage control wiring at air handlers and condensing units. Electricians rely on them for panel dressing and fixture rough-in. The 0.1-inch strap width and a maximum bundle diameter of 21 mm make this appropriate for small- to medium-diameter wire bundles. MOQ is 100 units per order.

Key Features

• 18 lb tensile strength for reliable bundle retention in standard-duty applications
• 4-inch overall length with 0.1-inch strap width suits small to medium wire bundles
• Maximum bundle diameter of 21 mm accommodates typical control wiring harnesses
• Operating temperature range of -40 degrees F to 185 degrees F for indoor and outdoor use
• Gray nylon construction resists moisture and common shop chemicals
• Meets MIL-S 23190E, MIL-SPEC M20693B, UL 94 V-2, and is UL Listed

Compatibility

Designed as a general-purpose standard cable tie for wire management and bundling tasks across electrical, HVAC, plumbing, and pool service applications where a 4-inch, 18 lb tensile-strength tie is appropriate.

Installation Notes

Cable ties are installed by electricians, HVAC technicians, and other trade professionals as part of wire management and harness organization work. No tools are required for hand-tensioning, though a cable tie gun improves consistency and flush cutting on production installs. Always de-energize circuits before dressing or securing wiring inside panels or equipment enclosures. Do not over-cinch ties on insulated conductors in a way that could damage the jacket.