Pro-source PS-MH-HOIST-006 Manual Lever Hoist 3000 Lb

Product Description

The PRO-SOURCE PS-MH-HOIST-006 is a manual lever hoist designed for controlled lifting and pulling of heavy loads up to 3000 pounds. Operated by hand with a lever force of 44 pounds, this hoist provides mechanical advantage for load positioning without the need for electric power or compressed air. It uses a single load chain and delivers up to 10 feet of lift height. Built for use in industrial, construction, and maintenance environments, the PS-MH-HOIST-006 is the tool of choice for riggers, millwrights, maintenance technicians, and contractors who need reliable lifting capacity in locations where powered hoists are impractical.

This lever hoist is suited for overhead lifting, load tensioning, and horizontal pulling in both permanent and temporary rigging setups. Typical applications include machinery installation and removal, pipeline positioning, structural steel erection, and equipment maintenance in plants or on job sites. The compact dimensions and single-chain design make it manageable in tight overhead clearances, with a minimum headroom requirement of 14.6 inches. It is appropriate for use in industrial facilities, commercial construction sites, and utility maintenance scenarios.

Key Features

• 3000 lb rated load capacity for heavy lifting and pulling tasks
• 10 ft lift height provides generous vertical range for most maintenance and rigging scenarios
• 44 lb lever operating force delivers mechanical advantage with reduced operator fatigue
• Minimum headroom of 14.6 inches allows use in confined overhead spaces
• Single load chain configuration for straightforward operation and inspection
• No power source required — fully manual operation for use anywhere on the job site

Compatibility

Designed as a general-purpose manual lever hoist for overhead and horizontal rigging applications in industrial, construction, and maintenance settings. Verify load rating and hook clearance against the specific application before use.

Installation Notes

Installation and operation of lever hoists must be performed by qualified riggers or maintenance personnel familiar with applicable ASME B30.21 standards for lever hoists. Before use, confirm that the overhead support structure is rated to handle the load being lifted plus the weight of the hoist. Always inspect the chain, hooks, and latch mechanisms for wear or damage before each use. Never exceed the rated load capacity and never use a hoist as a tie-down or load-securing device.