Pro-source PC62-DOT-8 Brass Push-to-connect Fitting 1/2 in

Product Description

The PRO-SOURCE PC62-DOT-8 is a brass push-to-connect tube fitting designed for quick, tool-free connections in pneumatic and fluid transfer lines. Built to DOT standards, this fitting accepts tubing with a 1/2 inch outside diameter and provides a secure, leak-resistant seal without threading or compression ferrules. The overall length measures approximately 46.60 millimeters (roughly 1.84 inches). Plumbers, HVAC technicians, and mechanical contractors install this type of fitting where fast assembly or frequent disconnection is required. The brass construction offers good corrosion resistance across a broad range of general-purpose service conditions.

This fitting is suited for general-purpose applications in residential and light commercial systems where DOT-compliant push-to-connect fittings are specified. Common install scenarios include compressed air distribution, pneumatic control lines, and fluid conveyance systems that use 1/2 inch OD tubing. Its straightforward push-in design reduces labor time during new installation and service calls where line repairs or reconfigurations are needed.

Key Features

• DOT-rated construction meets recognized standards for tube fitting integrity
• Brass body provides corrosion resistance in general-purpose service environments
• Push-to-connect design allows tool-free tube insertion for fast assembly
• Accepts 1/2 inch outside diameter tubing
• Overall length of approximately 1.84 inches (46.60 millimeters) for compact installation clearance

Compatibility

Designed for general-purpose use with 1/2 inch OD tubing in DOT-compliant pneumatic and fluid transfer applications.

Installation Notes

Installation is typically performed by licensed plumbers, HVAC technicians, or pipefitters working on pneumatic or fluid systems. Depressurize and isolate the line completely before inserting or removing the fitting. Ensure tubing ends are cut square and deburred before pushing into the fitting to achieve a proper seal. Verify that the tubing material and system pressure rating are compatible with the fitting before placing the line back into service.