Pro-source MB702272 Strip Brush 72 in Nylon Bristle

Product Description

The PRO-SOURCE MB702272 is a 72-inch overall length strip brush with a stainless steel back strip and nylon bristles. Strip brushes of this type are used to seal gaps, guide materials, or provide surface contact in industrial and light commercial applications. The back strip measures 5/16 inches wide, and the bristles extend 2 inches in length. The nylon bristle material resists moisture and mild chemicals, making this brush suitable for environments where some exposure to liquids or cleaning agents is expected. Licensed trades and maintenance professionals install these brushes in door seals, conveyor guides, machine enclosures, and similar applications.

This strip brush is suited for both commercial and light industrial installation scenarios. Common uses include door bottom seals, sliding door edge seals, machine guarding, and material handling guides. The 72-inch overall length allows the brush to span standard door widths or be cut to a required length in the field. The stainless steel back strip provides structural support and resistance to corrosion in damp or washdown-adjacent environments.

Key Features

• 72-inch overall length accommodates full door spans or can be trimmed to fit
• Nylon bristle material resists moisture and mild chemical exposure
• 5/16-inch wide stainless steel back strip provides rigid, corrosion-resistant support
• 2-inch bristle length provides substantial gap coverage or surface contact
• Single-piece construction for straightforward installation

Compatibility

Designed as a general-purpose strip brush for door sealing, machine guarding, and material handling guide applications requiring a 5/16-inch stainless steel back and 2-inch nylon bristles.

Installation Notes

Strip brushes of this type are typically installed by maintenance technicians or contractors using standard sheet metal screws or mounting clips appropriate for the back strip width. Measure and mark the mounting surface before fastening. The back strip can be cut to length with metal shears or an angle grinder. Ensure the mounting surface is clean and free of debris before installation to maintain a consistent seal or guide contact.