Pro-source CED6192-6-MSC Warning Cancel Wire Harness

Product Description

The PRO-SOURCE CED6192-6-MSC is a warning cancel wire harness designed to interface with vehicle or equipment warning systems. It provides a pre-terminated wiring solution that simplifies installation by eliminating the need to fabricate custom harness leads in the field. The harness is rated for both 12-volt and 24-volt systems, making it suitable across a range of light-duty and medium-duty applications. With a 9006-style base connector and a total length of 22 inches, it delivers a direct-fit connection point for technicians working on warning cancel circuits. The unit weighs 0.25 pounds and ships as a single-piece assembly.

This harness is used in automotive, fleet, and equipment service applications where warning cancel circuits require replacement or repair. The dual-voltage rating at 12/24V supports use in both standard passenger vehicle platforms and heavier commercial equipment. It is typically installed by automotive technicians, fleet maintenance professionals, or electrical specialists performing wiring repairs or upgrades on warning and safety systems. The 9006 base connector style provides a standardized mating interface commonly encountered in OEM and aftermarket warning system configurations.

Key Features

• Dual-voltage compatibility at 12/24V suits a wide range of vehicle and equipment platforms
• 9006-style base connector provides a standardized, direct-fit interface
• 22-inch harness length allows for flexible routing in tight installation environments
• Pre-terminated assembly reduces field fabrication time
• Lightweight at 0.25 pounds for easy handling during installation

Compatibility

Designed as a direct-replacement warning cancel wire harness for systems utilizing a 9006 base connector style operating on 12-volt or 24-volt circuits.

Installation Notes

Installation should be performed by a qualified automotive or electrical technician. Disconnect and isolate the vehicle or equipment power source before beginning any wiring work to prevent short circuits or damage to control modules. Route the harness away from heat sources, sharp edges, and moving components, and secure with appropriate fasteners or conduit as required. Verify connector seating and circuit continuity after installation before returning the system to service.