Pro-source 5575001045PRO Pneumatic Power Nibbler 16 Gauge

Product Description

The PRO-SOURCE 5575001045PRO is a pneumatic power nibbler designed for cutting sheet metal and similar materials in fabrication, HVAC, and mechanical trade applications. Powered by compressed air through a 1/4 NPT inlet, it requires 4 CFM of airflow and operates at up to 6.2 bar (90 psi). The tool delivers a 16 gauge cutting capacity, making it well suited for ductwork fabrication, flashing cuts, and light sheet metal work. At 2 pounds, it is compact enough for overhead or confined-space use. Licensed HVAC techs, sheet metal workers, and mechanical contractors are the primary users of this tool.

This nibbler is intended for trade environments where clean, burr-reduced cuts in sheet metal are required without distorting the material edge. Typical applications include HVAC duct fabrication, roofing flashing, automotive sheet metal, and general sheet metal fabrication shops. The pneumatic drive keeps the tool lightweight and eliminates heat buildup associated with electric alternatives, which is a practical advantage during extended cutting runs or in tight installation spaces.

Key Features

• 16 gauge cutting capacity suitable for standard HVAC duct and sheet metal stock
• 1/4 NPT air inlet compatible with standard shop air fittings
• 4 CFM air consumption rating for use with common trade compressors
• 6.2 bar (90 psi) operating pressure
• Compact 2-pound body for reduced fatigue during extended use
• Pneumatic drive eliminates the weight and heat of electric motors

Compatibility

Designed as a general-purpose pneumatic nibbler for use with standard 1/4 NPT compressed air supply lines found in trade and fabrication shop environments.

Installation Notes

Connection and operation should be performed by a qualified tradesperson familiar with pneumatic tool safety. Disconnect the air supply before changing cutting dies or performing any maintenance. Verify that the compressor output pressure and CFM rating meet or exceed the tool requirements before operation. Eye protection and cut-resistant gloves are standard PPE when operating any nibbler on sheet metal.