Pro-source 2555609265PRO Push-to-connect Tube Fitting 1/2 in

Product Description

The PRO-SOURCE 2555609265PRO is a push-to-connect tube fitting with a universal thread end, designed for fast, tool-free tube connections in compressed air and water systems. The body is constructed from nickel-plated brass, rated to 250 psi maximum working pressure. An integrated Buna O-ring provides a reliable seal across a working temperature range of 0 degrees F to 160 degrees F. The tube outside diameter is 8.00 mm. This fitting is installed by plumbers, HVAC technicians, and mechanical contractors in both residential and light commercial applications where quick-connect performance and corrosion resistance are required.

This fitting is suited for use in compressed air distribution lines and water supply systems where a push-to-connect tube interface meets a universal thread port. The universal thread configuration allows connection to a wide range of threaded ports without requiring a dedicated thread form match. Typical install scenarios include pneumatic controls, instrumentation lines, and general-purpose plumbing assemblies. Each package contains 5 fittings with a minimum order quantity of 1 package.

Key Features

• Push-to-connect design allows fast, tool-free tube insertion and secure retention
• Nickel-plated brass construction resists corrosion in air and water service
• Rated to 250 psi maximum working pressure
• Buna O-ring seal suitable for compressed air and water media
• Operating temperature range of 0 degrees F to 160 degrees F
• Universal thread end provides broad port compatibility

Compatibility

Designed for use with compressed air and water systems requiring an 8.00 mm outside diameter tube and a universal thread port connection. Consult system documentation to confirm thread form and tube OD before installation.

Installation Notes

Installation is typically performed by licensed plumbers or HVAC technicians. Depressurize and isolate the line before removing any existing fitting or inserting this one. Ensure the tube end is cut square, deburred, and clean before pushing it fully into the fitting body to seat the collet and O-ring. Verify system pressure does not exceed the 250 psi rated maximum after restoring service.