Pro-safe 400-B-20R Rubber Vertical Panel Base 20 Lb

Product Description

The PRO-SAFE 400-B-20R is a rubber vertical panel base designed to anchor and stabilize upright safety panels in industrial, construction, and facility environments. Weighing 20 pounds, this base provides the ballast needed to keep freestanding vertical panels secure without requiring permanent fastening to a floor or wall. Measuring 18.5 inches wide and 1.8 inches high, the low-profile rubber construction resists sliding and reduces trip hazards at ground level. It is installed by maintenance crews, safety personnel, and general contractors wherever temporary or semi-permanent panel barriers are required.

This base is suited for use in warehouses, manufacturing floors, construction sites, loading docks, and utility areas where vertical safety panels must stand independently. The rubber material absorbs impact and holds position on smooth or uneven concrete surfaces without damaging flooring. Its black color provides visibility contrast in high-traffic zones and resists fading in typical indoor and covered outdoor applications. The single-unit package makes it easy to deploy bases individually or in multiples along a panel run.

Key Features

• 20-pound rubber base provides stable ballast for freestanding vertical safety panels
• Low-profile 1.8-inch height minimizes trip hazard at floor level
• 18.5-inch width accommodates standard vertical panel footprints
• Rubber construction resists sliding on concrete and hard floor surfaces
• Black finish for high-visibility contrast in industrial environments
• No permanent fastening required for installation or removal

Compatibility

Designed as an OEM-style replacement or direct-fit base for standard rubber vertical panel barrier systems used in industrial and facility safety applications.

Installation Notes

Installation does not require tools in most configurations — the base slides onto or under the vertical panel foot according to the panel system design. Ensure the floor surface is clear of debris before positioning to maintain full contact and prevent rocking. For deployments in high-traffic or powered-vehicle areas, verify that the combined panel and base assembly meets applicable OSHA or facility safety barrier guidelines. No cutting, drilling, or adhesives are required for standard temporary installations.