Pps 85357 Press Pipe Cap 1/2 in 304 Stainless Steel

Product Description

The PPS 85357 is a 1/2-inch press-style pipe cap manufactured from 304 stainless steel and fitted with an FKM elastomeric seal. It is designed to terminate the end of a press-fit piping run without threading, soldering, or welding. The cap seats onto the pipe end and is pressed with a standard press tool to create a permanent, leak-tight connection. Rated to 200 psi and a temperature range of 0 to 284 degrees F, this cap suits demanding service environments. Licensed HVAC technicians, plumbers, and pipefitters working with stainless press systems are the primary installers.

The 85357 is suited for use in residential and commercial piping systems handling a range of media including compressed air, lube oil, slurry, aeration lines, sludge transfer, and additive systems. Its stainless steel construction and FKM seal make it a practical choice in corrosive or high-temperature service conditions where a carbon steel or copper cap would be inappropriate. The press-style end eliminates the need for open flame, making it well-suited for retrofit and confined-space installations.

Key Features

• 304 stainless steel body resists corrosion in aggressive media and wet environments
• FKM seal provides chemical resistance across a broad range of fluids
• Pressure rated to 200 psi for dependable performance in pressurized systems
• Temperature range of 0 to 284 degrees F covers most commercial and industrial service conditions
• Press-style connection eliminates open-flame soldering and threading
• 1/2-inch nominal size for standard piping termination in tight spaces

Compatibility

Designed for use in 1/2-inch press-fit stainless steel piping systems. Compatible with applications including compressed air, lube oil, aeration, sludge, slurry, and additive service lines.

Installation Notes

Installation requires a calibrated press tool compatible with the press-fit end style — do not attempt to hand-tighten or hammer the fitting onto the pipe. Depressurize and isolate the system before installing or removing any cap fitting. Plumbers and pipefitters should verify that the pipe end is clean, round, deburred, and free of debris before pressing. Follow all applicable local plumbing codes and manufacturer pressing guidelines for tool jaw selection and press confirmation.