Pps 691514781471 Copper Press Reducer 3/4 X 1/2 in

Product Description

The PPS 691514781471 is a copper press reducing coupling designed for fast, flame-free joining of copper pipe in a range of fluid and gas systems. At 3/4 x 1/2 in nominal size, it transitions between two pipe diameters using a press end connection on each side, eliminating the need for solder or open flame on the job. The fitting is rated to 200 psi and handles temperatures from 0 to 250 degrees F. At 2.07 inches in length, it fits cleanly in tight spaces. Licensed plumbers and mechanical contractors install this fitting using a compatible press tool and jaw set.

This reducing coupling is suited for residential and commercial applications including potable water distribution, hydronic heating, chilled water piping, compressed air, non-medical gas lines, fire sprinkler systems, and low pressure steam. Its press connection style makes it a practical choice on retrofit and new construction projects where open-flame work is restricted or impractical. The 3/4 x 1/2 in size is a common transition used in branch lines and fixture drops.

Key Features

• Press end style on both ends — no soldering required
• 200 psi pressure rating suitable for a wide range of mechanical systems
• Temperature range of 0 to 250 degrees F covers most HVAC and plumbing applications
• Copper construction for corrosion resistance and long service life
• Compact 2.07 inch length for installation in confined spaces
• Approved for potable water, hydronic heating, chilled water, compressed air, non-medical gases, fire sprinkler, and low pressure steam

Compatibility

Designed as an OEM-style press reducing coupling for use with standard copper press tooling systems in 3/4 x 1/2 in nominal pipe configurations across potable water, hydronic, and mechanical piping systems.

Installation Notes

Installation requires a licensed plumber or qualified mechanical contractor using a calibrated press tool with the correct jaw size for each end. Verify that pipe ends are cut square, deburred, and fully inserted to the depth mark before pressing. Follow all applicable local plumbing codes and IPC requirements for press-fit copper fittings. Depressurize and drain the system before cutting into any existing piping.