Potter Electric Signal PAD300-6DB 6 Detector Base

Product Description

The Potter Electric Signal PAD300-6DB is a 6-inch detector base designed for use with compatible smoke or heat detectors in fire alarm and life safety systems. The base provides a secure, standardized mounting point that connects the detector head to the wiring of the detection loop. Installation is typically performed by licensed fire alarm technicians or electricians working on low-voltage life safety circuits. The base simplifies detector replacement by allowing the head to be swapped without disturbing field wiring, a practical advantage in commercial and light industrial environments where system uptime is critical.

The PAD300-6DB is suited for commercial and residential fire alarm installations where a 6-inch detector base is required. It is intended for use as a detection accessory within addressable or conventional fire alarm panel systems. Typical applications include ceiling-mounted detector placements in office buildings, warehouses, and other occupancies that require consistent detector mounting geometry across an installation.

Key Features

• 6-inch base diameter provides a standardized detector mounting footprint
• Designed for low-voltage fire alarm detection loop wiring
• Allows detector head removal without disturbing field wiring connections
• Sold individually (each) for flexible procurement on single-point or multi-point installs
• Classified as a detection accessory for use in fire alarm system applications

Compatibility

Designed as an OEM-style replacement or installation base compatible with Potter Electric Signal detectors requiring a 6-inch mounting base. Verify detector head model compatibility with the PAD300-6DB before installation.

Installation Notes

Installation should be performed by a licensed fire alarm technician or electrician in accordance with NFPA 72 and applicable local codes. Power down the fire alarm panel or isolate the affected detection zone before wiring the base. Secure all field wiring connections per the detector manufacturer wiring diagram and confirm polarity where required. Do not energize the circuit until all connections are verified and the detector head is fully seated on the base.