Pip Industries MTL-OHW2-28/6FT Personal Fall Limiter 6 Ft

Product Description

The PIP INDUSTRIES MTL-OHW2-28/6FT is a twin-leg personal fall limiter (PFL) from the TurboLite Plus series, designed as a self-retracting lifeline (SRL) for workers who require mobility and reduced fall clearance on the job. The unit features a high-impact resistant nylon housing, abrasion-resistant retractable webbing, and an integral swivel to reduce lifeline twisting during movement. It carries a 420-pound weight rating and meets ANSI Z359.14-2021 Class 1 requirements. The twin-leg (dual-leg) configuration with rebar G2 connectors is intended for use by qualified safety professionals, ironworkers, and construction workers operating at height.

This personal fall limiter suits residential and commercial construction applications where workers need continuous 100-percent tie-off and freedom of movement across elevated work surfaces. The 6-foot retractable lifeline length makes it well suited for steel erection, concrete formwork, and elevated platform work where fall clearance is limited. The twin-leg design allows workers to transition between anchor points without disconnecting, a common requirement on ironwork and rebar-intensive job sites. The unit and lanyard end connectors include a rebar G2 hook configuration, matching the specific anchor hardware found on these applications.

Key Features

• 420-pound weight rating meets ANSI Z359.14-2021 Class 1 requirements
• Twin-leg (dual-leg) configuration supports 100-percent tie-off during anchor transitions
• Rebar G2 connectors at both unit and lanyard ends
• 6-foot retractable lifeline with abrasion-resistant webbing for extended service life
• Integral swivel reduces lifeline twisting during active movement
• High-impact resistant nylon housing with UV-resistant, scratch-proof labeling

Compatibility

Designed as an OEM-style personal fall limiter compatible with full-body harness systems aligned with Honeywell Miller harness designs for mix-and-match fall protection configurations. Consult the manufacturer documentation to confirm connector and anchor point compatibility before use.

Installation Notes

Installation and inspection must be performed by a competent person as defined under OSHA fall protection standards (29 CFR 1926.502). Power down or isolate all nearby energized equipment before working at height, and confirm the anchor point meets or exceeds the minimum rated load required by ANSI Z359.14. The twin-leg unit should be connected to a certified anchor before disconnecting from the previous anchor point to maintain continuous tie-off. Inspect the housing, webbing, swivel, and connectors before each use and remove from service immediately if any damage or locking-mechanism failure is detected.