Pip 19-D326/XS Cut Resistant Gloves Xs Ansi A3 Dyneema

Product Description

The PIP 19-D326/XS is a cut, puncture, and abrasion-resistant work glove built for trade professionals who handle sharp materials, sheet metal, glass, or rough surfaces. The glove is constructed from a Dyneema Diamond and Spandex shell knit at 13-gauge for a lightweight, form-fitting profile. A polyurethane coating covers the palm and fingers, providing grip and durability without sacrificing tactile sensitivity. Rated ANSI/ISEA Cut Level A3, Puncture Level 3, and Abrasion Level 5, this glove meets the demands of HVAC sheet metal work, electrical assembly, plumbing rough-in, and general trade applications. Overall length is 8.75 inches. The glove is sold as a pair.

The 19-D326/XS is suited for residential and commercial trade work where dexterity and cut protection must coexist. The seamless knit construction reduces pressure points during extended wear. The flat polyurethane grip surface handles dry and lightly oily conditions common in mechanical rooms, job sites, and fabrication environments. HVAC technicians, electricians, and plumbers who work with ductwork, conduit, pipe, and fittings will find the glove sized and rated for precision hand tasks at the XS end of the spectrum. Rated EN 388 4X42CX for international compliance.

Key Features

• ANSI/ISEA Cut Resistance Level A3 for protection against sharp edges and sheet metal
• ANSI/ISEA Puncture Resistance Level 3 for added protection against wire ends and fasteners
• ANSI/ISEA Abrasion Resistance Level 5 for durability on rough surfaces
• 13-gauge Dyneema Diamond and Spandex shell delivers lightweight dexterity and tactile feedback
• Polyurethane-dipped palm and fingers provide flat grip and wear resistance
• Seamless knit construction reduces interior seam irritation during extended use
• EN 388 rated 4X42CX for compliance in international work environments

Compatibility

Designed as an OEM-style cut and abrasion-resistant work glove for trade professionals requiring ANSI A3 hand protection in general mechanical, electrical, and plumbing applications. Part of the PIP Series 19-D326 glove line.

Installation Notes

These gloves are worn PPE and do not require installation tools or mechanical fastening. Inspect gloves before each use for tears, holes, or coating separation that would reduce protection. Gloves should be matched to the specific hazard level of the task — verify ANSI ratings against your site safety plan or applicable OSHA PPE requirements. Discard and replace if the shell or coating is compromised.