Pip 16-323/S Cut Resistant Gloves Size Small Ansi A2

Product Description

The PIP 16-323/S is a knit-style work glove rated for cut, puncture, and abrasion resistance, designed for trade and industrial applications where hand protection is a daily requirement. Built on a 15-gauge seamless PolyKor fiber shell, the glove carries an ANSI/ISEA Cut Level A2 rating and an ANSI/ISEA Abrasion Level 4 rating. The palm and fingers are coated with gray foam nitrile, providing grip in dry and light-moisture conditions. Sized for small hands and sold as a pair, this glove is appropriate for HVAC technicians, electricians, plumbers, and general trades workers handling sheet metal, conduit, pipe, or other abrasive materials.

This glove is suited for general trade and light industrial work where a balance of dexterity and cut protection is needed. The high-visibility yellow knit shell and cuff aid in visual identification on the job site. The foam nitrile palm coating delivers tactile feedback without sacrificing protection, making it practical for tasks requiring precise hand movement such as wire routing, fitting installation, or handling insulated ductwork components. The EN 388 rating of 4X31BX confirms performance validation against European cut, abrasion, and puncture standards in addition to the ANSI/ISEA ratings.

Key Features

• ANSI/ISEA Cut Resistance Level A2 and Abrasion Resistance Level 4 for multi-hazard hand protection
• 15-gauge seamless PolyKor fiber knit shell for consistent coverage and dexterity
• Foam nitrile palm and finger coating for grip on dry and lightly damp surfaces
• High-visibility yellow color on shell and knit cuff for jobsite visibility
• EN 388 rated 4X31BX, meeting both ANSI/ISEA and European PPE standards
• Unisex sizing — fits small for men, X-small for women

Compatibility

Designed as a general-purpose cut and abrasion-resistant work glove suitable for HVAC, plumbing, electrical, and light industrial applications where ANSI Cut Level A2 hand protection is required.

Installation Notes

Inspect gloves before each use for tears, coating delamination, or thinning at the fingertips. Replace when protective integrity is compromised. These gloves do not provide electrical arc flash protection, chemical resistance, or heat resistance beyond incidental contact and should not be substituted for task-specific PPE where those hazards are present. Consult applicable OSHA 29 CFR 1910.138 or 1926.28 requirements for hand protection selection guidance.