Pass Seymour PJSE8W Sectional Wall Plate Duplex End Section

Product Description

The PASS SEYMOUR PJSE8W is a white sectional nylon wall plate designed as an end section with a duplex outlet opening. It is part of a modular, sectional wall plate system used to cover single-gang or multi-gang electrical device installations. The plate is molded from self-extinguishing nylon, making it resistant to impact and flame. Its dimensions run slightly larger than standard plates, providing superior coverage over outlet cutouts and rough wall surfaces. Licensed electricians and finish trimmers install this plate during the final stage of residential and light commercial electrical rough-in completion.

This end section is used wherever a sectional wall plate assembly terminates at a duplex receptacle position. It is suited for residential wiring projects, light commercial buildouts, and renovation work where a clean, consistent sectional plate system is specified. The modular design allows multiple device configurations to be covered using matched center and end sections from the same product family. Each package contains 10 plates, making it practical for volume rough-in work or stocking a service van.

Key Features

• End section configuration with duplex outlet opening for sectional plate systems
• Molded from self-extinguishing nylon for flame resistance and long-term durability
• Slightly oversized profile compared to standard plates for improved wall coverage
• UL listed for code-compliant installations
• White finish for compatibility with standard white devices and trim
• Packaged 10 per package for efficient stocking and installation workflow

Compatibility

Designed as an end section for PASS SEYMOUR sectional nylon wall plate assemblies with duplex outlet openings. Intended for use with matching sectional center sections from the same product family to complete multi-device plate configurations.

Installation Notes

Installed by licensed electricians during the trim-out phase after all devices are mounted and wired. Power to the circuit must be shut off at the breaker before installing or adjusting any wall plates or devices. Align the plate flush to the wall surface and secure with the appropriate device screws. Follow NEC requirements for device cover installation in all applicable jurisdictions.