Pass Seymour 26016BKBPCC10 Quick Plug 6A 125V Black 10 Pack

Product Description

The PASS SEYMOUR 26016BKBPCC10 is a quick-connect plug designed for fast, tool-optional termination of low-voltage lamp and appliance cords. Rated at 6 amps and 125 volts, it uses insulation-piercing terminals that eliminate the need to strip wire ends before installation. The plug is polarized, meaning the blades are sized differently to enforce correct hot and neutral orientation. It is designed specifically for 18-2 SPT1 cord and is finished in black. Each blister pack contains 10 plugs. Electricians and maintenance technicians use this plug for cord repair, replacement outlet ends on light-duty appliances, and small lamp cord termination jobs.

This plug is suited for light-duty residential and commercial cord applications where 18-2 SPT1 flat lamp cord is used. Typical uses include replacement ends on extension cords rated for low-amperage loads, decorative lighting strings, and small plug-in appliances drawing no more than 6 amps at 120 volts. The insulation-piercing design makes it well suited for high-volume service calls or maintenance situations where speed of installation is a priority. The black finish matches standard black cord stock commonly used in display and accent lighting installations.

Key Features

• Insulation-piercing terminals allow termination without stripping cord insulation
• Polarized blade configuration enforces correct hot and neutral orientation
• Rated 6 amps at 125 volts for light-duty cord and lamp applications
• Compatible with 18-2 SPT1 flat cord only
• Black finish matches black flat lamp and appliance cord stock
• Pack of 10 plugs per blister card for stocking and service use

Compatibility

Designed for use with 18-2 SPT1 flat lamp cord in light-duty residential and commercial plug replacement applications rated at 6 amps and 125 volts maximum.

Installation Notes

Installation is performed by licensed electricians or qualified maintenance personnel. Power must be confirmed off at the source before any cord or plug work begins. No wire stripping is required with insulation-piercing terminals, but the cord must be fully seated and the terminal cap fully closed to ensure a reliable connection. Work must comply with applicable NEC requirements for cord and plug-connected equipment.