Parker H1EVXBG023D 4-way 2-position Solenoid Valve Bspp

Product Description

The PARKER H1EVXBG023D is a 4-way, 2-position solenoid valve designed for pneumatic control applications. It operates in a normally open configuration through ports 1 and 2, meaning flow passes through the circuit unactuated until the solenoid is energized. The valve body is aluminum with a nitrile seal, and it runs on 120 VAC. With a Cv rating of 1.5, it delivers reliable flow capacity for standard pneumatic circuits. Licensed HVAC technicians, industrial maintenance techs, and pneumatic system specialists are the typical installers. The valve carries IP65, ISO 1179, and cCSAus certifications, making it suitable for environments where moisture ingress protection and international standards compliance are required.

This valve is suited for pneumatic directional control in light to medium industrial and commercial applications. The BSPP thread standard makes it compatible with subbase and manifold assemblies that conform to ISO 1179 specifications. It handles a working temperature range of 5 degrees F to 120 degrees F, covering most indoor and protected outdoor pneumatic service environments. It is not intended for hydraulic or high-pressure fluid service. The aluminum body keeps overall weight low at 1.7 pounds, which simplifies manifold assembly and subbase mounting configurations.

Key Features

• 4-way, 2-position directional control valve for pneumatic circuits
• Normally open through ports 1 and 2 in unactuated state
• BSPP thread standard with ISO 1179 manifold and subbase port compliance
• IP65 rated for protection against dust ingress and low-pressure water jets
• cCSAus approved for use in North American installations
• Aluminum body with nitrile seals for lightweight, chemical-resistant construction

Compatibility

Designed for use with BSPP manifold and subbase assemblies meeting ISO 1179 specifications in pneumatic directional control systems.

Installation Notes

Installation should be performed by a qualified technician familiar with pneumatic system lockout and tagout procedures. Depressurize the system completely before removing or installing any valve. Verify that the supply voltage matches the 120 VAC coil rating before energizing the valve. Refer to applicable local codes and the manufacturer wiring diagram for proper electrical termination.