Parker 62NFBH-10 Brass Compression Bulkhead Union 150 Psi

Product Description

The PARKER 62NFBH-10 is a brass compression bulkhead union fitting designed to create a secure, leak-free tube connection through a panel or bulkhead wall. It accepts compression fittings on both ends, allowing a continuous tube run to pass through and seal against a partition without welding or brazing. Rated to 150 psi maximum working pressure and suitable for service between -40 and 200 degrees F, this fitting is well suited for refrigeration lines, pneumatic circuits, and fluid transfer systems where a panel penetration is required. Plumbers, HVAC technicians, and mechanical contractors install this type of fitting when routing tubing through equipment enclosures, machine frames, or control panels.

The 62NFBH-10 is used in light commercial and industrial applications where tubing must pass cleanly through a bulkhead. Typical install scenarios include refrigeration equipment cabinets, hydraulic or pneumatic control panels, and process equipment enclosures. The compression-by-compression end configuration makes it compatible with standard soft or hard tubing without requiring flare tools or soldering equipment. Its brass construction provides corrosion resistance appropriate for air, water, and many common refrigerants and fluids within the rated pressure and temperature range.

Key Features

• Compression x Compression end connections on both sides for tool-free tube insertion and secure grip
• Brass body construction for corrosion resistance and reliable sealing
• 150 psi maximum working pressure rating
• Wide service temperature range from -40 to 200 degrees F
• 0.398 inch inside diameter for consistent flow with matched tubing
• Bulkhead union design locks the fitting in place through a panel, keeping both sides accessible

Compatibility

Designed as an OEM-style replacement or new-installation component for compression tube systems requiring a bulkhead panel penetration fitting.

Installation Notes

Installation is typically performed by licensed plumbers, HVAC technicians, or mechanical contractors. Before installing, relieve all system pressure and isolate the line from any fluid or refrigerant source. Drill or deburr the panel hole to the correct diameter before inserting the bulkhead body and securing the locknut. Do not overtighten the compression nuts by hand; use wrenches to achieve a snug, leak-free connection without deforming the ferrule or tubing.