Panduit H1.5X3WH6 Slotted Hinged Wire Duct Pvc

Product Description

The PANDUIT H1.5X3WH6 is a slotted hinged wire duct manufactured from PVC, designed to route, organize, and protect electrical wiring and low-voltage cabling within control panels, enclosures, and industrial equipment. The hinged cover design allows technicians to access conductors after installation without removing the duct from its mounting surface. At 1.5 inches wide by 3 inches tall, this duct provides substantial wire capacity while maintaining a compact footprint inside panel interiors. Slotted sidewalls allow wires to exit the channel at any point along the run, keeping installations clean and serviceable.

This wire duct is suited for use in residential, commercial, and light industrial electrical enclosures and control panels. It is commonly installed in motor control centers, PLC panels, HVAC equipment control sections, and custom panel builds where organized wire management is required. Electricians and panel builders use this duct to separate power and signal wiring, reduce clutter, and maintain compliance with wiring neatness standards in inspected installations.

Key Features

• Slotted sidewalls allow wire egress at any point along the duct length
• Hinged cover provides quick access to conductors without unmounting the duct
• PVC construction resists moisture and common panel-environment chemicals
• 1.5 inch width by 3 inch height profile accommodates high conductor fill capacity
• Suitable for organizing power, control, and low-voltage signal wiring

Compatibility

Designed as an OEM-style wire management solution compatible with standard panel-mount and DIN-rail enclosure installations where slotted hinged PVC duct is specified.

Installation Notes

Installation is typically performed by licensed electricians or panel builders during enclosure assembly or retrofit. De-energize the panel and follow applicable NFPA 70 (NEC) lockout/tagout procedures before routing or securing conductors. The duct is typically fastened to the panel back plate using screws through the duct base at regular intervals. Avoid over-filling the duct beyond its rated wire capacity, as this can prevent the hinged cover from closing properly and may create heat buildup.