Panduit FZTYP7EL2SAF300 OM4 12-fiber Trunk Cable Ofnp

Product Description

The PANDUIT FZTYP7EL2SAF300 is a pre-terminated OM4 multimode fiber optic trunk cable rated OFNP (plenum) and terminated with PanMPO connectors on both ends in a female-to-female configuration. Designed for high-density structured cabling systems, this 12-fiber trunk assembly supports high-bandwidth backbone and data center interconnect runs where plenum-rated cable is required by code. Licensed electricians and low-voltage cabling technicians are the primary installers. The OFNP rating makes it suitable for installation in air-handling plenum spaces without conduit.

This trunk cable is used in enterprise data centers, campus backbones, and high-density patch environments where pre-terminated assemblies reduce installation time and labor. The PanMPO interface is designed for use with PANDUIT OptiPatch and compatible high-density cassette and module systems. The 12-fiber count supports parallel optic applications including 40G and 100G structured cabling architectures. This cable is sold as a single assembly unit.

Key Features

• OM4 multimode fiber supports high-bandwidth 40G and 100G parallel optic applications
• OFNP plenum rating meets NEC requirements for installation in air-handling spaces without conduit
• PanMPO connectors on both ends in female-to-female configuration for direct cassette or module termination
• 12-fiber count in a single trunk assembly for high-density backbone routing
• Pre-terminated factory assembly reduces field labor and eliminates field splicing

Compatibility

Designed for use in high-density OM4 multimode structured cabling systems using PanMPO-compatible cassettes, modules, and patching equipment.

Installation Notes

Installation is typically performed by licensed low-voltage cabling technicians following ANSI/TIA-568 structured cabling standards. De-energize all connected active equipment before mating or un-mating MPO connectors to avoid damage to optical transceivers. Use appropriate MPO cleaning tools on all connector end-faces before insertion. Avoid bending the cable tighter than the minimum bend radius specified for the cable assembly to prevent signal loss.