Norton 66623325035 Quick-change Disc 2 in Fine Grade

Product Description

The NORTON 66623325035 is a 2-inch non-woven quick-change abrasive disc from the Bear-Tex Rapid Prep series, engineered for surface conditioning, weld blending, and finishing on a wide range of metals. It uses vortex agglomerated aluminum oxide grain bonded to a high-loft nylon web backing with proprietary Clean Bond resin technology. The fine grade construction delivers consistent, controlled material removal without aggressive gouging. Rated to 30,000 RPM, this disc attaches via a Type R (Speed-Lok TR) quick-change system, making tool-free disc swaps fast on compatible die grinders and handheld disc sanders. Each unit weighs 0.01 pounds.

This disc is suited for light deburring, blending, and surface prep work in both shop and field environments. It performs on 300 and 400 series stainless steel, brass, bronze, cast iron, copper, ductile iron, fiberglass and composites, gray iron, hard and soft carbon steels, super alloys, titanium, and tool steels. The flexible nylon web backing allows the disc to conform to irregular or contoured surfaces, making it practical for weld seam blending and finish work where a rigid disc would leave flat spots. Compatible machines include die grinders and handheld disc sanders equipped with a Speed-Lok TR or Type R arbor.

Key Features

• Vortex agglomerated aluminum oxide grain for consistent cut rate and long disc life
• High-loft nylon web backing conforms to contoured and irregular work surfaces
• Proprietary Clean Bond resin technology bonds grain uniformly across the disc face
• Type R Speed-Lok TR quick-change attachment allows tool-free disc changes
• Fine grade construction suited for weld blending, light deburring, and surface conditioning
• Rated to 30,000 RPM for use with standard die grinders and handheld sanders

Compatibility

Designed for use with die grinders and handheld disc sanders equipped with a Speed-Lok TR or Type R quick-change arbor. Compatible with 300 Series Stainless, 400 Series Stainless, Brass, Bronze, Cast Iron, Copper, Ductile Iron, Fiberglass/Composites, Gray Iron, Hard Carbon Steels, Soft Carbon Steels, Super Alloys, Titanium, and Tool Steels.

Installation Notes

Install and remove this disc only with the grinder or sander powered off and disconnected from its power source. Verify that the tool arbor is a Speed-Lok TR or Type R quick-change type before mounting. Do not exceed the 30,000 RPM maximum speed rating. Inspect the disc for damage before each use and discard any disc that shows tears, delamination, or signs of worn attachment hardware.