Norton 66252835165 Aluminum Oxide Cutoff Wheel 6 in 60 Grit

Product Description

The NORTON 66252835165 is a Type 1 (flat profile) resinoid-bonded aluminum oxide cutoff wheel designed for cutting steel in demanding trade applications. Measuring 6 inches in diameter and 0.06 inches thick with a 1-1/4 inch arbor hole, this wheel operates at up to 10,190 RPM. The aluminum oxide grain at 60 grit delivers aggressive cutting action on ferrous metal. Both sides are reinforced for added structural integrity during cut-off work. At approximately 0.18 pounds, it is a lightweight consumable suited for circular saw use in fabrication, mechanical, and maintenance applications.

This cutoff wheel is intended for steel cutting applications using compatible circular saws that accept a 6 inch diameter, 1-1/4 inch arbor wheel. It is appropriate for use in metal fabrication shops, HVAC ductwork rough-in, pipe cutting, and general mechanical service work where a thin-kerf abrasive cut-off is required. The Type 1 flat wheel profile is standard for straight cut-off operations. Specification code A60-OBNA2 identifies the exact abrasive formulation for referencing replacements or matching to existing wheel specs.

Key Features

• 6 inch diameter Type 1 flat cutoff wheel profile for straight cut-off operations
• Aluminum oxide abrasive at 60 grit for aggressive ferrous metal cutting
• Resinoid bond construction with O hardness grade for controlled wear
• Both sides reinforced for structural integrity under lateral load
• 10,190 maximum RPM rating for use with compatible circular saws
• 1-1/4 inch arbor hole fits standard circular saw spindles

Compatibility

Designed for use with circular saws that accept a 6 inch diameter abrasive cutoff wheel with a 1-1/4 inch arbor hole. Rated for steel cutting applications per manufacturer specification A60-OBNA2.

Installation Notes

Installation and wheel changes should be performed by a qualified operator following ANSI B7.1 safe-use guidelines for abrasive wheels. Always power down and disconnect the saw before mounting or removing a wheel. Inspect the wheel for cracks or chips before each use and do not use a damaged wheel. Verify that the saw spindle speed does not exceed the 10,190 RPM maximum rating marked on the wheel.