Norgren M20600100 Union Tee Fitting 1/8 Inch Od Brass

Product Description

The NORGREN M20600100 is a push-to-connect union tee fitting designed for tube-to-tube connections in pneumatic and fluid control systems. Built from brass, it accepts 1/8 inch outside diameter tubing on all three ports, allowing a single inline connection point to branch into two directions without tools. The fitting is rated to 150 psi maximum working pressure and operates across a temperature range of 0 to 175 degrees F. The nitrile O-ring seals deliver reliable leak resistance under pressure cycling. HVAC technicians, plumbing contractors, and fluid system installers use this fitting where a compact, low-effort tube junction is needed in tight spaces.

This union tee is suited for residential and light commercial pneumatic control lines, instrument air tubing, and low-pressure fluid distribution circuits. Its push-to-connect design eliminates the need for flare tools, compression sleeves, or thread sealant at the joint. The 0.67 inch overall length keeps the fitting footprint minimal, making it practical for panel-mounted or cabinet-installed tubing runs where space is limited.

Key Features

• Push-to-connect design on all three ports — no tools required for tube insertion
• Brass body construction for corrosion resistance in pneumatic and compatible fluid service
• Rated to 150 psi maximum working pressure
• Operating temperature range of 0 to 175 degrees F
• Nitrile O-ring seals provide reliable pressure retention under cycling conditions
• Compact 0.67 inch overall length for tight installation environments

Compatibility

Designed for use with 1/8 inch outside diameter push-to-connect tubing in pneumatic instrumentation and low-pressure fluid control systems.

Installation Notes

Installation is performed by a licensed plumber, HVAC technician, or qualified instrumentation technician depending on the system. Before servicing any tubing connection, depressurize and isolate the line completely. Ensure tubing ends are cut square and deburred before insertion to achieve a proper seal with the O-ring. Verify that the selected tubing material and wall thickness are compatible with the fitting's rated pressure and temperature limits before placing the system into service.